📙
The CTA+dCache Book
  • Preface
  • Chapter I - Introduction
    • I - CTA basic concepts
    • II - CTA services
  • Chapter II - Getting started
    • I - Preinstallation steps
      • Know your tape library with mtx and mt
      • The IBM Tape Diagnostic Tool (ITDT)
    • II - Installation guide
      • dcache-cta plugin installation
    • III - Configuration guide
      • Setting up your dCache pool
    • IV - Logical structure setup guide
  • Chapter III - Other procedures
  • Chapter IV - FAQ & troubleshooting
    • I - FAQ
    • II - Troubleshooting
  • Chapter V - Useful links
Powered by GitBook
On this page

Chapter II - Getting started

In this chapter you will find a complete step-by-step installation on CentOS7.

Note that these steps are oriented to configure CTA as dCache's tape backend, therefore some parts may differ if you are using EOS as your disk storage system!

  • I - Preinstallation steps

    • Know your tape library with mtx and mt

    • The IBM Tape Diagnostic Tool (ITDT)

  • II - Installation guide

    • dcache-cta plugin installation

  • III - Configuration guide

    • Setting up your dCache pool

  • IV - Logical structure setup guide

PreviousII - CTA servicesNextI - Preinstallation steps

Last updated 2 years ago